Heel and Toe Protectors Steel Segs

German-made Triumph metal segs to protect and extend the life of shoe and boot soles. Used by cobblers, shoe repair shops, and DIY enthusiasts. A simple fix that saves money on professional repairs.

• Triumph metal segs. Made in Germany
• Metal toe and heel protectors sold as pairs
• Size 10 toe & heel protector 25 × 9mm
• Size 11 toe & heel protector 30 × 9mm
• Size 12 toe & heel protector 35 x 9mm
• Size 14 heel protector for shoe size 2.5" to 3" wide - 48 x 10 mm
• Size 15: heel protector for shoe size heels 3" to 4" - 55 × 10mm
• Size 16: heel protector
• Rex toe protectors size 19 - 25 x 10mm
• Rex toe protector size 20 - 30 x 12 mm
• Rex toe protector size 21 -35 x 12  mm

How to fit heel and toe protectors

1. Measure the toe width of the shoe sole to determine the correct size.
2. Mark the nail hole positions on the sole with a pen.
3. For leather soles: pilot holes using a drill or sharp bradawl. Lightly dampen the toe area with water before fitting.
4. For rubber soles: no dampening required.
5. Position the seg and hand-drive 2 nails at either end to hold it in place.
6. Adjust until correctly aligned, then drive all nails in by hand.
7. Use a hammer to tap nails firmly and evenly until the seg is secure.